A numerical study of the motion of a wave running up a beach

The main difficulty for the numerical calculation of the wave running up a beach is the treatment of its moving water boundary. In this paper a scheme of turning the free boundary problem into a fixed boundary problem is designed. The calculated run-up height is consistent with the experiments. Some interesting wave phenomena are also found.     

混合状态Hamiltonian元的半解析解和叠层板的计算

本文给出混合状态方程的一种强有力的半离散半解析解法,并给出了矩形域和叠层板的算例,讨论了可能的发展和应用。     

不同边界条件正交各向异性中厚板的振动与稳定分析

本文采用高阶剪切变形理论对正交各向异性中厚矩形板进行振动与稳定分析,数值计算采用样条有限点法,得出了六种不同边界条件矩形板的自振频率和屈曲载荷,并与相应的经典板理论的结果进行比较.结果说明横向剪切变形对复合材料层合板的影响与板的各向异性程度、板的宽厚比(b/h)、层合板的层数和板的支承条件有关,它随着层合板各向异性程度的增加而增加,随着层合板宽厚比的增加而逐渐消失.     

Reisner板的哈密尔顿体系及其辛正交解析法

基于Ｒｅｉｓｎｅｒ板理论，通过对混合能变分原理的修正，建立了更一般的哈密尔顿型广义变分原理，并给出了Ｒｅｉｓｎｅｒ板问题的哈密尔顿正则方程及其共轭辛正交解析法     

Dynamic compressive strength properties of aluminium foams. Part I—experimental data and observations

This study of the dynamic compressive strength properties of metal foams is in two parts. Part I presents data from an extensive experimental study of closed-cell Hydro/Cymat aluminium foam, which elucidates a number of key issues and phenomena. Part II focuses on modelling issues.The dynamic compressive response of the foam was investigated using a direct-impact technique for a range of velocities from 10 to . Elastic wave dispersion and attenuation in the pressure bar was corrected using a deconvolution technique.A new method of locating the point of densification in the nominal stress-strain curves of the foam is proposed, which provides a consistent framework for the definition of the plateau stress and the densification strain, both essential parameters of the ‘shock’ model in Part II. Data for the uniaxial, plastic collapse and plateau stresses are presented for two different average cell sizes of approximately 4 and 14 mm. They show that the plastic collapse strength of the foam changes significantly with compression rate. This phenomenon is discussed, and the distinctive roles of microinertia and ‘shock’ formation are described. The effects of compression rates on the initiation, development and distribution of cell crushing are also examined. Tests were carried out to examine the effects of density gradient and specimen gauge length at different rates of compression and the results are discussed. The origin of the conflicting conclusions in the literature on the correlation between nominal strain rate (ratio of the impact velocity V_i to the initial gauge length l_o of the specimen) and the dynamic strength of aluminium alloy foams is identified and explained.     

惯性约束聚变靶丸内杂质气体抽空流洗过程的数值模拟

低温冷冻靶是实现惯性约束聚变(inertial confinement fusion,ICF)的关键部件之一.低温靶靶丸内杂质气体的去除程度和效率对低温靶燃料冰层的在线制备具有重要意义.依据低温靶物理对冰层杂质含量的设计要求,在计算靶丸内杂质气体最大允许分压的基础上,建立了靶丸内气体在微米级充气管内流动的抽空流洗模型.模拟研究了不同微管尺度及结构、温度对靶丸内杂质气体抽空流洗效率的影响规律,获得了靶丸充气微管的最佳管型设计方案.基于最佳管型设计,优化得到了具有最高抽空流洗效率的抽空时间与流洗次数组合策略.     

气体团簇离子束两步能量修形法的平坦化效应

本文提出采用气体团簇离子束的两步能量修形法来改善4H-SiC(1000)晶片表面形貌.先用15 keV的高能Ar团簇离子进行整体修形,再用5 keV的低能团簇离子优化表面.结果表明,在相同的团簇离子剂量下,与单一15 keV的高能团簇处理相比,两步法修形后的表面具有更低的均方根粗糙度,两者分别为1.05 nm和0.78 nm.本文还以原子级平坦表面为研究对象,揭示了载能团簇引起的半球形离子损伤(弧坑)与团簇能量的关系,及两步能量修形法在弧坑修复中的优势.在原子力显微镜表征的基础上,引入了二维功率谱密度函数,以直观全面地给出材料的表面形貌特征及其随波长(频率)的分布.结果表明,经任何能量的团簇离子轰击的表面,在0.05—0.20μm波长范围内,团簇轰击都能有效地降低粗糙度,而在0.02—0.05μm范围内,则出现了粗化效应,这是由于形成了半球形离子损伤,但第二步更低能量的团簇离子处理可以削弱这种粗化效应.     

Highly sensitive electrochemical immunoassay for zearalenone in grain and grain-based food

We have developed a highly sensitive electrochemical immunoassay for the quantitation of zearalenone (ZEN), a mycotoxin produced by Fusarium species. In this enzyme linked immunosorbent assay, the enzymatic conversion of the substrate p-nitrophenylphosphate is detected by a microplate reader and the signal subsequently converted into an electrical signal. The concentrations of coating antigen (ZEN-ovalbumin), of monoclonal antibody, and of goat anti-mouse antibody labeled with alkaline phosphatase were optimized. In terms of electrochemical detection, the types and pH values of the buffers, the conditions for agitating, and scanning frequency were optimized. The effective detection range of this immunoassay is quite wide (0.004 to 9.5 ng?mL^?1), and the limit of detection is 2 pg?mL^?1. ZEN-free corn, wheat, and grain-based food samples were spiked with ZEN and analyzed by this method, and recoveries were found to range from 91.6 % to 113.0 %. Unlike previously described electrochemical methods, this method is both highly sensitive and has a wide working range. The method is fast and thus provides a platform for high-throughput analysis that meets the current need to monitor trace levels of analytes in grain and grain-based food.

A SERS-based immunoassay for porcine circovirus type 2 using multi-branched gold nanoparticles

We report on a facile immunoassay for porcine circovirus type 2 (PCV2) based on surface enhanced Raman scattering (SERS) using multi-branched gold nanoparticles (mb-AuNPs) as substrates. The mb-AuNPs in the immunosensor act as Raman reporters and were prepared via Tris base-induced reduction and subsequent reaction with p-mercaptobenzoic acid (pMBA). They possess good stability and high SERS activity. Subsequently, the modified mb-AuNPs were covalently conjugated to the monoclonal antibody (McAb) against the PCV2 cap protein to form SERS immuno nanoprobes. These were captured in a microtiterplate via a immunoreaction in the presence of target antigens. The effects of antibody concentration, reaction time and temperature on the sensitivity of the immunoassay were investigated. Under optimized assay conditions, the Raman signal intensity at 1,076 cm^?1 increases logarithmically with the concentrations of PCV2 in the concentration ranging from 8?×?10² to 8?×?10⁶ copies per mL. The limit of detection is 8?×?10² copies per mL. Compared to conventional detecting methods such as those based on PCR, the method presented here is rapid, facile and very sensitive.